Gate motor failing or automation system acting erratically? We specialize in gate motor replacement, control board repair, sensor alignment, and complete automation system diagnostics for residential and commercial gates.
GET AN ESTIMATE
Gate automation systems are complex electromechanical assemblies — combining motors, gearboxes, control boards, sensors, and communication modules. When automation fails, the issue could be mechanical wear, electrical faults, or software configuration. Our approach is systematic: we isolate the failed component and repair or replace only what's necessary.
Gate motors endure daily start-stop cycles, exposure to weather, and significant mechanical loads. We replace failed motors with OEM or compatible units matched to your gate's weight and operating requirements. For commercial operators, we also offer motor rebuild services.
Modern gate control boards manage open/close timing, safety sensor inputs, access control signals, and battery backup. We read fault codes, test inputs and outputs, and replace boards when repair isn't feasible. Programming is included with every board replacement.
Photo-eyes, ground loops, and edge sensors must be precisely calibrated for reliable operation. Drift in sensor alignment is a leading cause of intermittent gate behavior. We recalibrate all sensors and verify detection zones during every automation service.
Many gate operators include battery backup for power outage operation. We test and replace backup batteries, verify charging circuits, and install solar panel systems for gates in remote locations or properties seeking independence from utility power.
Licensed technicians, commercial-grade parts, and a diagnostic-first approach. We identify the problem, explain your options, and deliver a lasting repair.
Signs include excessive noise during operation, slow or inconsistent movement, the motor running but the gate not moving, overheating, or the breaker tripping when the gate activates. If the motor is drawing excessive current, replacement is typically the most reliable solution.
Yes. In most cases, the control board can be replaced independently. We stock boards for major brands and can often source discontinued boards through our supplier network. Programming your access codes and settings onto the new board is included.
This is usually triggered by a safety device detecting an obstruction — real or phantom. Misaligned photo-eyes, damaged edge sensors, or incorrect force settings can all cause premature reversal. We test each safety input individually to identify the trigger.
Yes. We install, maintain, and repair solar panel systems for gate operators. This includes panel cleaning, battery replacement, charge controller testing, and troubleshooting power delivery issues. Solar systems are excellent for hillside properties and remote driveways.
Gates and garage door services across Los Angeles County — from the Westside to the Valley.
Tell us what you need. Our team reviews every request and calls you back within the hour to confirm your appointment.